To re-pair with Windows 10, I removed Nintendo RVL-CNT-01 from Bluetooth, I then go to Control Panel, Add Device, and then I add Nintendo RVL-CNT-01 with blank PIN. I have to do this process every time with WinUSoft after the Wii Remote is turned off. This process has not worked with WinUPro for me.
I don't have any Nintendo consoles for my Wii Remote to sync with.
Another thing I notice is when running WinUPro 32-bit on my Windows 10 64-bit, my Wii Remote pairs with WinUPro 32. I hear a "Battery Low" (sometimes), I can open the button mapping option, but WinUPro 32 crashes moments after the pairing.
Try removing your Wiimote from Bluetooth. Then open WiinUPro and click the small sync button just under the home tab, then press the red sync button on your Wiimote. See if can connect it. If so, only disconnect your Wiimote by holding its power button and reconnect it by pressing the A button.
Hi Justin, I was able to remove the Wii Remote from Windows Bluetooth devices and have it pair with the WinUPro sync for the 64-bit. Unfortunately, I get a 'Failed- Unable to Connect Device' message.
I did notice that Windows Bluetooth automatically repaired with the Wii Remote, even though I removed it earlier. I removed the Wii Remote from Windows Bluetooth Devices again, re-synced with WinUPro, but now I have two Wii Remote devices on WinUPro. Each Wii Remote Device I have paired with WinUPro fails to connect.